Fill the reservoir, run it all the way up and all the way down. It should self bleed.
You may have to add more fluid to get proper service/level.
You may have to add more fluid to get proper service/level.
help with tilt/trim motor replacement
I'm replacing the tilt/trim motor on my old nissan outboard. My question is how do I bleed the system after it's installed? I don't see any bleed fittings like you would find on a brake system. Do I just keep filling the resevior while running it up and down? Do I try to pre-charge the ram before connecting the lines to the pump? Should I run the t/t motor or move the outboard up and down manually till the system is charged? Thanks in advance of any advise.
1 - 3 of 3 Posts
Thanks for the info LowerUnit...had to help it up the first time by pulling on the outboard with the t/t motor running. ran it back down, refilled the reservoir, and it worked fine after that.
1 - 3 of 3 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Arizona Fishing Forums on AZBZ
A forum community dedicated to anglers and fishing enthusiasts in Arizona. Come join the discussion about safety, gear, tackle, tips, tricks, reviews, reports, accessories, classifieds, and more!
Full Forum Listing
Explore Our Forums
