Arizona Fishing Forums on AZBZ banner
1 - 1 of 1 Posts

·
Registered
Joined
·
5,343 Posts
The only way to properly mount it is to fiberglass a board to the hull. go to home depot get a piece of poplar or any hardwood about an inch wider on each side and an inch longer on the top and bottom. bevel the sides and coat it with fiberglass resin. cut your carpet where you want to mount it and sand down to bare glass. coat the bottom of the boat and the board with the resin then set it down. place fiberglass cloth about 4 inches wide all around the edges and glass it in. now you will have to replace the carpet where you cut it out. simple
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top